 |
 |
 |
|
The SIALOR 6103 Multi Alarm Panel connects to VHF equipment, MF/HF equipment and Inmarsat C equipment, and has a distress button for each type of system. The display shows distress messages received. It also indicates equipment type (VHF, MF/HF or Inmarsat C) when the equipment is detected by the Multi Alarm Panel. Through the Ethernet connector you can interface up to two Inmarsat C systems, two VHF systems and two MF/HF systems. The Alarm Panel is supplied from 10.8 - 32 V DC. The input is protected against reverse polarity. In Inmarsat C GMDSS systems it is mandatory to have two distress buttons. If you have a Mini-C GMDSS system, only one alarm panel is required, because the Message Terminal, which is part of the system, has a distress button.
- Mounting method: Flush mount or bracket
- Power: 10.8 to 32 V DC, with “remote on/off” input
- Power Consumption: Typical 1 W, Maximum 3 W
- Interfaces: Ethernet (10/100 Mbit), RJ45 connector DC input, custom panel lock connector
- Compliance: • IEC 60945 • Wheelmark approved.
- IP protection: IP30
- Ambient Temperature: -15°C to 55°C
- Storage temperature: -40°C to 80°C
- Relative humidity: +40°C 93% 1 cycle
- Vibration: Vibration Sweep: 2 Hz - 13,2 Hz at ± 1 mm 13,2 Hz - 100 Hz at 7m/s2 2 h dwell at each resonance, otherwise 2 h at 30Hz in all three axes
- Compass safe distance: 1 m
- Dimensions H x W x D: Without bracket: 107 mm x 121 mm x 55 mm, With bracket: 124 mm x 153 mm x 90 mm
- Weight: Without bracket: 302 g, With bracket: 440 g
|
|
|
 |
|
 |
|
|
|
 |
|
 |
|
Features & Benefits
- The distress buttons are protected by a spring loaded cover to avoid unintended activation of a distress alert
- The Alarm Panel can be easily installed at the conning position on the bridge
- If a distress alert is initiated on a system with duplicated units, only one of the units will send the alarm
|
|
|
|
|
|
|